Size Guide Belts Women

The size of belt needed will depend on how/where you want to wear it.

You can be a size 12 / M in jeans and require a size 14 / L  belt if you want to wear it on your hips.


Please use the table below as a guideline only, for our stock belts.

These are body measurements taken over the article of clothing you will be wearing your belt with.

If you need a size not shown, please see the BESPOKE – MADE TO ORDER service for further information.  We are happy to make the size you want.

A size 8/XS , a McRostie belt will measure 26” from the leather end of the buckle to the middle of five holes, unless stated otherwise.  These holes are spaced at intervals of 25mm/1”.

SIZE to ORDERBody measurement Waist in cmBody measurement Waist in inchesFastens at the middle hole  of 5 holes, leaving two spare either side.
6 / XXS602461cm / 24”
8 / XS6525.566cm / 26”
10 / S7027.571cm /28”
12 / M7529.576cm / 30”
14 / L8031.581cm / 32”
16/ XL8533.586cm / 34”
18 / XXL9035.591cm / 36”
20 / XXXL9537.596cm / 38”


If your size is not mentioned in the table above, or falls between sizes, we are happy to make you a belt to your own requirements.

With a made to measure belt, you can also choose the number of holes you would like to have, the spacing between them, the length from the last hole to the tip of the belt or request other features.

Please read the bespoke tab on the product page or click ‘here ‘(Please insert a link to the ‘Made to Order’ page in the Bespoke Category) to contact our Made to Order Service.  There is an extra charge for this.

How to measure your belt size:   Take a belt you wear comfortably and measure from the leather end of the buckle ( do not include the buckle in the measurement) to the hole you buckle at.   This is the size to order. If this measurement is 35.5” we will make your belt to measure 35.5” from the leather end of the buckle to the middle of 5 holes, allowing your waistline to expand a little or contract a little.  These holes are normally approx.1” apart.

Sorry this website requires JavaScript to be enabled to work correctly!